NOTICE: has been archived.

The archive will be available at for approximately one year (through September 2020). If you use or are responsible for content here that is not yet available elsewhere, please contact the PWD Digital Team.

Winter Ice Removal

How Does Ice Removal Affect Stormwater?

  • Salt used to melt ice on streets, sidewalks and steps runs off into our storm sewers and eventually the Delaware and Schuylkill Rivers, our drinking water source.
  • Salt can damage and kill vegetation as well as endanger freshwater ecosystems and aquatic life.
  • Safe and Effective Winter Ice Removal

  • All de-icing materials can be harmful to the environment, so the best strategy is to use as little as necessary.
  • Before applying de-icers, always shovel sidewalks and pathways to keep them clear and to prevent ice from forming.
  • Salt and de-icers are not effective when more than 3 inches of snow have accumulated.
  • Salt Alternatives

  • Calcium magnesium acetate (CMA) is the most environmentally friendly de-icer. Northern states use CMA on roads in sensitive areas (wetlands, drinking water supply, etc.). However, CMA does not work well below 25° Fahrenheit and it is the most expensive de-icer.
  • Corn byproducts are effective de-icers recycled from mills and breweries. However, they can have extremely high phosphorus content, a major water pollutant.
  • Chloride (salt-based) products such as potassium chloride, calcium chloride and magnesium chloride are less harmful to the environment than salt. Check product labels for chemical content to find them at your local hardware store.
  • Chloride products often perform best when used in combination with salt. They will increase efficiency by reducing the amount of salt necessary.
  • Sand can be used in conjunction with any of these de-icers to add traction.

  • Photo: CT Post

    How to Apply De-Icers

  • Only use de-icers on clear paths that have been shoveled or plowed. They will not work in 3 inches or more of snow.
  • Refrain from using de-icers prior to a storm. If de-icers are applied and a storm does not occur, sweep up all unused material and store it for reuse after the next big storm.
  • Focus de-icers on high-use areas and slopes where traction is critical. Apply the least amount necessary to get the job done. This will save money and minimize damage to paved surfaces, vehicles and vegetation while reducing the environmental effects.
  • Use a variety of de-icing products (mentioned above) to improve the effectiveness of salt and reduce the amount needed.
  • Plant native vegetation that is salt tolerant in stormwater drainage swales and ponds that may receive salt-laden runoff. These plants will act as an effective buffer for our local waterways.
  • Store salt and other products in a dry, covered area on an impervious (impenetrable) surface, such as a basement floor, to prevent ground contamination.
  • If you observe ineffective ice management or poor application on streets and sidewalks, such as excess piles of road salt left to disperse, share your concerns with your property manager or call the City of Philadelphia Streets Department Hotline: 215-686-5560.
  • Disclaimer

    This website content is provided to you on an “AS IS” and “WITH ALL FAULTS” basis. You acknowledge that you assume the entire risk of loss in using this information, including without limitation any loss incurred by any End User. You further acknowledge that this content is complex and may contain some nonconformities, defects and/or errors. PWD does not warrant that this website will meet your needs or expectations, or that all nonconformities can or will be corrected. PWD assumes no risk, liability or responsibility for the accuracy of this guide. See full disclaimer